Regulations for general tolerance in existing drawings are included in clause 5.*This standard is the technical revision of the standard which has been published in 2010-01. DIN 6930-1 is valid for the technical delivery conditions of stamped parts. This standard shall be applied in conjunction with the specifications given in DIN 6932. If, by way of exception, it is intended to apply this standard also to components made from semi-finished products other than flat products, or from materials other than steel, this shall be particularly agreed. General tolerances for parts made by fine blanking are not covered in this standard. They shall apply whenever reference is made to this standard on drawings or relevant documents (e. It specifies general tolerances on linear and angular dimensions and on coaxiality and symmetry in four accuracy grades which are meant for use and hot stampings made from steel flat products. Most recent DIN 6930-2:2011 Stamped steel parts - Part 2: General tolerances (Foreign Standard) This standard is intended to simplify drawings. General tolerance: DIN ISO 2768-mh-E DIN EN ISO 13920-Bf DIN 6930-m type series: semifinished part: 10525.Din 6930-2: 2011: stamped steel parts - part 2: general tolerances: din hdbk 67: 5ed 2013: din 9003-5: 1986: aerospace bending of light metal sheet and strip dimensions, limit deviations and compensation values: din 18360: 2019. Ĭustomizable tolerance table for the ISO system of fits and tolerances corresponding to DIN ISO 286 Part 1. ĬATIA Integrated Solution to Leverage the Production Part. DIN EN 186 Parts 1 and 2, December 1991Editions, Supersedes DIN 18166. Permissible Deviations According to ISO Tolerance Zone h7 (Oct) 59361. Installation tolerance Operatingtolerance Wear and tear wear and Turbulence Tolerance Test Endurance Test Closing Balance Ducati Multistrada 1200 S. 6.2 Straightness tolerance for stripand sections. 6930-2:2011-10 (E) Stamped steel parts - Part 2: General tolerances Contents Page. se p?edevm o nep?edepsan mezn chylky dlkovch a hlovch rozm?r? a nep?edepsan geometrick tolerance). Veobecn? platn smluvn podmnky realizace dla conditions forstampings are coverd by DIN 6930 Part 1. A tolerance chart is a graphical method for presenting the manufacturing dimensions of a. Tolerance of the bending angleD according to SN 6935.
flame cutting, laser cutting, plasma cutting) DIN ISO 9013. ĭIN 7168 - m DINnumber Tolerance class m as per clause 3 of this standard 5.2 Designation of general tolerances based onISO 8015 Example: DIN 7168 - m - S DIN numberĪppendix 36 INT Sheet Metal Parts and StampingsĭIN 6930 : Thermal cutting (e.g. General tolerances for Iinearand angular DIN dimensions and.
0 kommentar(er)
