paxpuppy.blogg.se

Snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart ! Tell the device which IP addresses are allowed to connect for HTTP (ASDM) access and from which interface ! enable the HTTP service on the device so that you can connect to it for ASDM access ! SSH access will use the LOCAL username/password for authentication Timeout sip-provisional-media 0:02:00 uauth 0:05:00 absoluteĭynamic-access-policy-record DfltAccessPolicy

! Tell the appliance where the asdm image is located.

Icmp unreachable rate-limit 1 burst-size 1 ! name also the interface as “management” ! Configure IP address to Interface GigEth5 and put a high security level (90 is good). ! Configure an “enable password” which is the administrator password of the deviceĮnable password 2KFQnbNIdI.2KYOU encrypted The management PC is running also a TFTP server software (tftp32) which will be used to transfer the ASDM image to the ASA.īelow is the CLI configuration used in this initial setup (see video below also for more information): We will configure Interface GigabitEthernet 5 as a management interface with IP address 10.10.10.1/24.Īlso, on the same subnet we have our management PC with IP address 10.10.10.10/24. First we need to have console access (with a serial console cable) to the device in order to configure some initial settings to allow user access with ASDM or with SSH.